1. It is important to note that pedals are sided. Remember this is
always from the perspective of the rider. Locate the left hand
side/ right hand side pedal, which is marked "L" and "R".
2. The thread on the left hand pedal is reversed. So tighten it
counter-clockwise. Install the left hand pedal into the left crank
arm gently by hand. Then tighten the pedal by a 15mm wrench.
3. The right hand pedal has a normal thread. So tighten it
clockwise. Install the right hand pedal into the right crank arm
gently by hand. Then tighten the pedal by a 15mm wrench.
Adjusting the Seat Position and Angle
To change the angle and horizontal position of the seat:
1. Use a 6 mm Allen wrench to loosen the seat adjustment bolt on
the clamp positioned underneath the seat, above the rear wheel.
Do not remove the bolt fully.
2. Move the seat backward or forward to adjust the angle. A seat
position horizontal to flat ground is desirable for most riders.
3. While holding the seat in the desired position, use a 6 mm allen
wrench to tighten the seat angle adjustment bolt securely to the
recommended torque value.
To Next Page
Loading...
