Phocos CA06-2.1 - Page 21

Connect the wires leading to the solar
array with correct polarity. To avoid
any voltage on the wires, first connect
the controller, then the solar array.
Keep in mind the recommended wire
size:
CA06-2.1: min. 2.5mm
2
CA08-2.1: min. 4mm
2
CA10-2.1: min. 6mm
2
CA14-1.1: min. 10mm
2
18
Connect the wires leading to the
loads with correct polarity. To avoid
any voltage on the wires, first
connect the wire to the load, then
to the controller. Keep in mind the
recommended wire size:
CA06-2.1: min. 2.5mm
2
CA08-2.1: min. 4mm
2
CA10-2.1: min. 6mm
2
CA14-1.1: min. 10mm
2
REMARK: place positive and negative wires leading to the solar
generator close to each other to minimize electromagnetic
effects.
REMARK: Solar panels provide voltage as soon as exposed to
sun light. Keep in mind the solar panel manufacturers
recommendations in any case.