Need help?Do you have a question about the Phoenix Contact FL SWITCH 2208 and is the answer not in the manual?
General| Number of ports | 8 |
|---|---|
| Port type | RJ45 |
| Switching speed/capacity | 1.6 Gbps |
| Power Supply/Operating voltage | 24 V DC |
| Weight | 0.5 kg |
| Mounting type | DIN Rail |
| Protection class | IP20 |
| Type | Managed Switch |
| MAC address table size | 8000 entries |
| Redundancy | Yes |
Explains hazard symbols and signal words like DANGER, WARNING, CAUTION.
Emphasizes that installation must be performed by qualified and instructed personnel.
Details the properties and available versions of the FL SWITCH 2000 series.
Details the steps for mounting the device onto a DIN rail and removing it.
Describes how to connect the 24 V DC power supply to the device.
Explains the importance and procedure for grounding the device for safety and interference shielding.
Covers the process of assigning IP parameters using the BootP protocol.
Covers system settings, administrator password, quick setup, and network parameters.
Configures network services, port settings, VLANs, and multicast filtering.
Configures RSTP, MRP, security features, and DHCP service.
Details how to establish a connection to the switch's CLI.
Explains the syntax, structure, and help features of CLI commands.
Explains the basic principles, architecture, and SNMP interface.
To Next Page
