6 OF 12—FAN STATIC RESET KIT MKT-0266 MPC-1480 ©2010 Phoenix Controls Specifications subject to change without notice. Rev. 5/10
6. Cut it to length and connect it to the appropriate port on the sensor.
• Upstream or "fan side" of the valve connects to the "H" (high) port on the sensor.
• Downstream or "room side" of the valve connects to the "L" (low) port on the sensor.
NOTE: Make certain the tubing is not kinked and not in a position where moving parts on the valve could pinch or cut it.
7. Secure the tubing to the duct using the enclosed tie wraps and adhesive backed holders, or duct tape so that it cannot become
tangled with any moving equipment in the area.
WARNING: Phoenix Controls recommends a "drip loop" somewhere along the tubing run to prevent moisture or
condensation from reaching the ports on the pressure sensor. Moisture will damage the sensor beyond repair.
To Next Page
Loading...