Need help?Do you have a question about the Phoenix Gold XS4300 and is the answer not in the manual?
Details on front panel controls like sensitivity, bass EQ, crossovers, and input connections.
Details on rear panel controls like crossovers, fade, sensitivity, bass EQ, and inputs.
Information on connecting speaker outputs and the function of isolation mounting feet.
Guide to B+, B-, R terminals, and DC power fuses for amplifier connection.
Visual representation of how audio signals travel through the amplifier.
Essential steps for planning vehicle system installation, including electrical inspection and cable routing.
Guidelines and diagrams for designing a system with a single PowerFlow amplifier.
Guidelines and diagrams for designing systems with multiple PowerFlow amplifiers.
Illustrations of various output setups using different crossover and speaker configurations.
Precautions and recommendations for securely mounting the amplifier in a vehicle.
Guide to connecting line-level and hi-level audio signals to the amplifier.
Instructions for connecting power, ground, remote turn-on, and speaker wires.
Details on adjusting crossover frequencies using optional resistor networks (RNets).
Procedure for accessing and replacing resistor networks (RNets) inside the amplifier.
How to set input sensitivity and bass equalization controls for optimal performance.
Details on front panel controls like sensitivity, bass EQ, crossovers, and input connections.
Details on rear panel controls like crossovers, fade, sensitivity, bass EQ, and inputs.
Information on connecting speaker outputs and the function of isolation mounting feet.
Guide to B+, B-, R terminals, and DC power fuses for amplifier connection.
Visual representation of how audio signals travel through the amplifier.
Essential steps for planning vehicle system installation, including electrical inspection and cable routing.
Guidelines and diagrams for designing a system with a single PowerFlow amplifier.
Guidelines and diagrams for designing systems with multiple PowerFlow amplifiers.
Illustrations of various output setups using different crossover and speaker configurations.
Precautions and recommendations for securely mounting the amplifier in a vehicle.
Guide to connecting line-level and hi-level audio signals to the amplifier.
Instructions for connecting power, ground, remote turn-on, and speaker wires.
Details on adjusting crossover frequencies using optional resistor networks (RNets).
Procedure for accessing and replacing resistor networks (RNets) inside the amplifier.
How to set input sensitivity and bass equalization controls for optimal performance.
General| Channels | 4 |
|---|---|
| Power Output (RMS) @ 4 ohms | 75W x 4 |
| Frequency Response | 10 Hz - 30 kHz |
| Signal-to-Noise Ratio | > 100 dB |
| THD at Rated Power | <0.05% |
| Input Sensitivity | 200 mV - 4 V |
| Crossover Slope | 12 dB/octave |
| Fuse Rating | 30 A |
| Bass Boost | 0-12dB @ 45Hz |
To Next Page