Phoenix Model trainer 60 - Setting Up the Throttle

Antenna exit
9
This is a very important stage in the completion of the model. The throttle must open and close fully - without
the linkage binding at either end of its travel. Work by setting the "mid throttle" position first, followed by the
low and high. Once the linkage has been properly set-up it can be adjusted mechanically or by using the
Travel Adjust, or ATV/EPA feature on most modern transmitters.
SETTING UP THE THROTTLE
Low throttle Mid throttle High throttle
Mid throttle stick position
Low throttle stick position High throttle stick position
Instruction Manual
Trainer 60
36
Wrap battery and receiver in protective
foam padding.
Install the switch.
Receiver-battery
37
Switch