EasyManuals Logo

Phoenix DryMAX 4036000 User Manual

Phoenix DryMAX 4036000
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
6
USEPHOENIX.COM
1.800.533.7533
3.3.18 Diagnostic Mode - Float Switch
This display will communicate to the user the current status
of the Float Switch.
Press the Next button to advance to the next screen.
3.3.19 Diagnostic Mode - Intake RH Offset
The Intake RH Offset allows you to calibrate the DryMAX to
match your favorite meter.
Press the Set button to adjust the intake RH in 1%
increments ranging from -20% to 5. Negative values will
reduce the RH on the display of the DryMAX.
3.3.20 Diagnostic Mode - Fan
Press the Set button to toggle the Fan On/Off.
Press the Next button to advance to the next screen.
3.3.21 Diagnostic Mode - Compressor
Press the Set button to toggle the Compressor On/Off.
Press the Next button to advance to the next screen.
3.3.22 Diagnostic Mode - Display Test
Press the Set button to start the Display test.
3.3.23 Diagnostic Mode - Refrig. Test
The display will communicate to the user the following
information during a Refrigeration Test:
Inlet = Temperature and RH/Grains
Outlet = Temperature and RH/ Grains
Hours = Life hours only.
Evaporator Coil = Temperature
Countdown timer = 20 minutes
Once the 20 minute countdown timer has expired, the
display will automatically advance to show the refrigeration
test results. The display will communicate to the user either
“Refrig. test passed” or “Refrig. test failed”.
Press the Next button to return to the first diagnostic test or
press and hold the Next button for 3 seconds to return to the
Dashboard.
3.4 Condensate Removal
The Phoenix DryMAX is equipped with an internal
condensate pump to remove the water that is condensed
during dehumidification. This allows the condensate to be
pumped up to 20 feet with the attached hose. If the
condensate must be pumped more than 20 feet above the
unit, a second pump must be added to relay the condensate.
The condensate pump automatically purges when the
reservoir is full. Use the PURGE button to manually remove
condensation.
Toll-Free 1-800-533-7533

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Phoenix DryMAX 4036000 and is the answer not in the manual?

Phoenix DryMAX 4036000 Specifications

General IconGeneral
BrandPhoenix
ModelDryMAX 4036000
CategoryDehumidifier
LanguageEnglish

Related product manuals