6. Led Status Light
Light
Solid blue
Blue flashing slowly
Blue flashing quickly
Solid red
Redflashing slowly
Red flashing quickly
Solid purple
Purple flashing quickly
7. Maintenance
Printer head cleaning steps
Printer status
Standby and Ready
Label jams or label detection error
Wrong media tracking
Printer head is over-heated
Papershortage
Cover is not closed
Printing
Pause printing
1. Turn the printer off , remove the power cord and open the cover. (See picture 1)
2. Wait until the printer head cools down . (The printer head may be very hot after
printing)
3. Completely clean the printer head using an alcohol swap (Not with water).
(Seepicture 2)
4. Wait until the alcohol has completely vaporized, then close the cover.
5. Connect the power cord and print a test page to check if it is clean.
Picture 1
NOTICE
Picture 2
Ensure power is off when performing maintenance.
Do not touch or scratch the printer head, the roller or the sensors.
8. Tips for Preparation
I. Avoid using poor quality labels as they may damage the printer.
2. Clean the printer head regularly.
3. Connect the printer to the same USB port on your computer every time. This
can avoid creating duplicate copies on the printer.
4. If paper isjammed, pleasereferto "Printer headCleaningSteps"in "7.Maintenance".
9. Safety Notices
1.DOnot bend the power cord excessively or place objects on the cord.
2. Keep the printer out of reach of children.
3. Use only approved accessories and do not try to disassemble or repair the unit
by yourself.
4. Keep the printer away from water and other objects that could penetrate the
components.
5. Unplug the printer when it is not in use for long periods.
6. Do not use the printer if you find any irregularities as these could result in fire or
electrocution.
7. Do not touch the printer head. Theprinter headcanbeover-heatedafterprinting.
To Next Page
Loading...
