Phonetics Sensaphone 800 - Page 44

To program the ID Message:
1. Press the SET key.
SET
2. Press the MESSAGE key. The 800 will say “Enter Message
Number.”
MESSAGE
3. Press the ID key (number 0 key).
0
ID NUMBER
POWE
R
4. When the unit beeps, begin speaking your message into the
microphone. The unit will say “OK,” when the recording
time has elapsed; then it will play back your recorded
message.
To play back the ID Message:
1. Press the WHAT IS key.
WHAT
IS
2. Press the MESSAGE key.
MESSAGE
3. Press the ID key (number 0 key).
0
ID NUMBER
POWER
The 800 will play back your recorded message.
The Zone Messages are used to identify the device or condition
being monitored such as temperature, humidity, equipment
alarms, security alarms, etc.
Sensaphone
®
Model 800 User’s Manual
41