Phonocar VM 017 - Technical Specifications; General Specifications; Radio and Disc Player Specs; Display and FM Radio Specs

38
Technical Specications
General
Power supply 12V DC(11V-16V)
Test voltage 14.4V, negative ground
Maximum power output 50Wx4 channels
Continuous power output 25Wx4 channels (4 10% T.H.D.)
Suitable speaker impedance 4-8 ohm
Pre-Amp output voltage 4.0V(CD play mode: 1KHz, 0 dB, 10K load)
Fuse 15A
Dimensions(WxHxD) 178x50x166mm
Weight 2.2kg
Sub-out 4.0V
Aux-in level ≥ 300mV
3.5 Inch TFT LCD
Display Resolution(dot) 320×(RGB)×234
Active area(mm) 76.32(H)×42.822(V)
Screen size(inch) 3.5 (16:9l)
Dot pitch(mm) 0.2385(H)×0.183 (V)
Contrast ratio 350
Brightness 350 nits
FM Stereo Radio
Frequency range 87.5-108.0 MHz (Europe)
87.5-107.9 MHz (America)
Usable sensitivity 8 dBμ
Frequency response 30 Hz-15KHz
Stereo separation 30dB(1 KHz)
Image response ratio 50dB
IF response ratio 70dB
Signal/noise ratio >55dB
Note: Specications and the design are subject to change without
notice due to improvements in technology.
AM(MW) Radio
Frequency range 522-1620 KHz (Europe)
530-1710 KHz (America)
Usable sensitivity(S/N=20dB) 30 dBμ
Disc Player
System Disc digital audio system
Frequency response 20 Hz - 20 KHz
Signal/noise ratio >80 dB
Total harmonic distortion Less than 0.20%(1 KHz)
Channel separation >60dB
Video signal format system PAL/NTSC/AUTO
Video
Video output 1 ± 0.2V
Horizontal nesowtiou ≥ 500 lines
Components
Mounting collar 1
Machine screws M5x6 mm 4
M4x6 mm 4
Mounting bolt (50 mm) 1
Wire connector 1
Removable face plate case 1
Trim plate 1
T-key 2
Operating Instructions 1
Rubber cushion 1
Remote control 1