Phottix Indra360 TTL - Custom Functions; Custom Function Table; Replacing the Flash Tube

12
En
INSTRUCTION MANUAL
2. Press Function button 1 or Function button 2 to cycle through the menu
items – C.Fn 00 to 03.
3. Turn the “Adjust/Set knob” to change the functions within the menu.
4. Press Function button 4 to exit the C.Fn menu.
Custom Functions Chart
Custom Functions
The Phottix Indra360 TTL Studio Light comes with a number of programmable
custom functions. To edit these functions (see below):
1. Press and hold Function button 4 and the “Adjust/Set knob” for 3 seconds to
enter the C.Fn Menu Screen.
Replacing the ash tube
1. Disconnect the Indra360 TTL Studio light from a power source for 10
minutes before changing the ash tube.
2. Remove the Reector as shown above.
3. Gently separate the Glass Dome from the snap mount, remove the Glass
Dome. (Picture 10)
4. Gently hold the ash tube to remove it from the snap slot. (Picture 11)
5. Insert a new ash tube into the snap slot. (Picture 12)
6. Mount the Glass Dome align the snap mount. (Picture 13)
7. Attach the Reector as shown above.
Note: Please wear gloves instead of touching the ash tube directly when
replacing the ash tube.