Phottix Odin - TCU Advanced Settings and Controls; EV, Manual, and Off Group Settings; Ratio Screen Adjustments; Saving Settings and Fast Exit

En
INSTRUCTION MANUAL
Pressing the TCU Power Button after making
changes to settings will exit edit mode. The
TCU will save the current settings.
Fast Exit
The Selection Button allows you to cycle
through A:B ratio adjustments, EV adjustments
and Channel selections.
Ratio Functions Screen
Pressing the TCU Power Button after making
changes to settings will exit edit mode. The
TCU will save the current settings.
Fast Exit
9
EV level of each group can be adjusted up or
down (see above).
M: Flashes are set in Manual mode and power
levels adjusted up or down (see above).
O: Selecting O (signied by three
underscores _ _ _) will turn o the selected
group and not re any remote ashes in that
group.
Press the Selection button to access Ratio
adjustments. Press the + / - button until the
desired A:B ratio is achieved.
Pressing the Selection button again will move
the active selection to the EV adjustment
section. Press the + / - button until the desired
EV level is achieved.
The Selection Button can also be used to navi-
gate to the Channel icon. The - / + buttons will
change the transmission channel (1, 2, 3 or 4)
when Channel is selected. This will change the
channel the TCU uses to transmit.