measurement, record the current value, and shut off the analyzer.
CAUTION: Never allow emissions port to be restricted, this
will produce back pressure in the sensor, and will cause erroneous
readings and possible damage to the sensor.
3.9 Data storage: (data storage function by default is turned off)
3.9.1 Data storage function turned on: In measuring interface, holding
the “Confirm/Save” key (about 3 S), will open the storage function, at
the same time, the flash storage icon will begin flashing at the center
bottom of the screen.
3.9.2 Data storage function turned off: In measuring interface, holding
the “Confirm/Save” key (about 3 S)), the storage function will be
closed; Storage icon will disappear.
3.9.3 Storage interval setting: To enter setup interface, choose the
"Storage Settings", and select the storage time interval setting desired;
3.9.4 Storage capacity: Up to 10000 data points. When full capacity,
To Next Page
Loading...