Handling information
NOTE: Oxygen sensors are sealed and under normal
circumstances their contents do not present a health hazard. The
following information is given as a guide in the event of a leak.
Hygienic practices: Wash hands after handling.
Protective clothing: Rubber gloves, chemical splash goggles.
Clean up procedures: Wipe down the area several times with a wet
paper towel. Using a fresh towel each time .
Protective measure during sensor replacement：
Before opening the bag containing the sensor, check the sensor for
leakage. If any leakage is found, do not open the bag. If there is liquid
around the sensor installed in the instrument, put on gloves and eye
protection before removing it.
NOTE: The above information is derived from the supplier’s
MSDS. This information is believed to be correct, but is not
necessarily inclusive, thus should be used only as a guide.
Phymetrix shall not be held liable for any damage arising out of
using or abusing this product.
To Next Page
Loading...