Piaa RF6 - Light Aiming and Troubleshooting; Spot Light Aiming; Troubleshooting Guide

-14-
PKI-0041-5-E
 1 Afterinstallation,ifthelampdoesnotactivate
   → Checkthewiringandmakesuretherearenofaultyorirregularconnections.
  ●Iftheswitchilluminationdoesnotlightup.
   → Verifythe(+)wirefromtheswitchisproperlyconnected.Ifitisnotcorrectlyconnecteditwillnotactivate.
   → Verifythefuselocatedonthevehicle
'
swiringsystem.(theswitch
'
s(+)wireshouldbeconnectedtothe
    fusebox).Ifitisburnedout,connectittoanothercircuit.
   → Iftheswitchitselfisfaulty,thesamesymptomsmayexist.Werecommendthattheentireswitchunit
    bereplaced.
   → Checkthefusefortheswitchharness.Ifitisburnedout,followinstructionsindicatedin
    [3FusereplacementProcedures].
  ●Theswitchilluminationlightsupbutwhenoperatingdoesnotwork.
   → Checktheconnecting(-)cordtothebodyearth.
   → Theremaybecaseswhereeachterminalrelatedtospecificsectionsmaybeincorrectlyconnected.
    Checkforanylosewiresandalsofordirtorgrime.
   → ChecktheswitchoperationIfanabnormalityisfound,replaceitaccordingly.
 2 IftheLEDsuddenlyfailstolightup…
   → Checkthefuselocatedonthevehicle
'
swiringsystem.Ifitisburnedout,replaceaccordingly.
   → Checkthefusefortheswitchharness.Ifitisburnedout,followinstructionsindicatedin
    [3FusereplacementProcedures].
   → Theremaybecaseswhereeachterminalrelatedtospecificsectionsmaybeincorrectlyconnected.
    Checkforanylosewiresandalsofordirtorgrime.
   → Checktheswitchoperationifanabnormalityisfound,replaceitaccordingly.

3 Fusereplacementprocedures
→ Ashortcircuitmayhaveoccurred.Checkthewiringsystem.Ifanytypeofdamageis
    foundreplaceaccordingly.(Non-replacementmayposeapotentialdanger)(Shortcircuitsaremainly
    causedwhenwiresarecaughtintheassemblyorwhenthereisagapinthesleeveconnectedtothe
    lampharness).
【8】Troubleshooting……
Verifyeachsectionaccordingtothefollowing.
Typically,drivinglightsaremountedabovethefrontbumperabout30inchesfromthegroundtoprovideextrahigh
beamillumination.Drivinglightscanbemountedbelowthebumper,althoughtheywillnotbeaseffectivebecause
thelightwillhitthegroundsoonerandreducetherangeofthelight.
Visualaimismadewiththecenterofthebeamhotspot1.5inchesbelowthelampcenterat25feetwiththelamp
facingstraightforward.(seebelow.)
● Donotusedrivinglightsinto
 oncomingtraffic.
 Drivinglightsshouldneverbe
 theonlyforwardlightsource.
 Drivinglightsshouldonlybe
 usedwiththeheadlamphigh
 beams.
1.5
DRIVING ／ SpotLightAiming