Operation
Each time the ignition switch B» is removed while in the «OFF» or «LOCK» positions,
the protection system activates the engine lock. Turning the ignition key «B» to
«ON» disables the engine lock, provided that the safety system recognises the code
transmitted by the key. If the code is not recognised, turn the ignition switch B» first
to «OFF» and then back to «ON» again; if lock persists, try again using the «A» MAS-
TER key. If the engine cannot be started, contact an Authorised Service Centre,
which is provided with the electronic equipment required to detect and repair the sys-
tem.
When the supplementary starter keys are required, remember that the all the keys,
whether new or existing, should be programmed.
Contact an Authorised Service Centre and bring the «A» MASTER key and all
«B» starter keys that you own.
The codes of starter keys not submitted for the new programming procedure are de-
leted from the memory. Any lost starter keys will therefore not be enabled to start the
engine.
WARNING
EACH KEY HAS ITS OWN AND UNIQUE CODE, WHICH MUST BE STORED IN
THE SYSTEM CONTROL UNIT MEMORY.
VIOLENT SHOCKS MAY AFFECT THE ELECTRONIC COMPONENTS OF THE
KEY.
IF THE VEHICLE IS SOLD, THE MASTER-HANDGRIP KEY (AS WELL AS THE
OTHER STARTER KEYS) AND THE «CODE CARD» MUST ALSO BE TRANS-
FERRED TO THE NEW OWNER.
19
To Next Page
Loading...
Need help?
General