03_51
Periods of inactivity (03_51)
The following operations are recommended:
1. Clean the scooter thoroughly and then cover it with a canvas;
2. With the engine off and the piston at the bottom dead centre position, remove the
spark plug, and pour 1 ÷ 2 cm³ of the recommended oil through its hole. Operate the
starter button 1-2 times for roughly 1 second to turn the engine over slowly, then insert
the spark plug again;
3. Ensure that the fuel tank is at least half full (so that the fuel pump is fully
covered); spread antirust grease on the uncoated metal parts; keep the wheels lifted
above the ground by resting the chassis on two wooden wedges;
4. As regards the battery, follow the instructions in the «Battery» section.
Recommended products
eni i-Ride PG 5W-40
Synthetic based lubricant for high-performance four-stroke engines.
JASO MA, MA2 - API SL - ACEA A3
Cleaning the vehicle
Use a low pressure jet of water to soften the caked dirt and mud deposited on the
painted surfaces. Once softened, sponge off mud and dirt using a car body sponge
soaked in a car body shampoo and water solution (2-4% of car shampoo in water).
Then rinse with abundant water, and dry with a shammy cloth. For the engine exterior,
use petrol, a brush and clean cloths. Petrol can damage paintwork. Remember that
any polishing with silicone wax must always be preceded by washing.
CAUTION
THE VEHICLE COMPARTMENTS ARE NOT WATERTIGHT.
98
To Next Page
Loading...
Need help?
General
