EasyManua.ls Logo

Piazzetta Multifuoco 2003 - Troubleshooting Common Issues; Modifying Remote Control Frequency Code; Wireless Control Light Not Turning On; Remote Control Works, Receiver Does Not Respond

Piazzetta Multifuoco 2003
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
49
10. TROUBLESHOOTING
MODIFYING THE FREQUENCY CODE
In there is other equipment with the same frequency code as your remote control you can modify the broadcasting
channel as follows:
UNDO THE SCREW ON THE BACK OF THE COVER WITH A PHILIPS SCREW DRIVER AND OPEN THE REMOTE CONTROL
P
OSITION THE MICROSWITCHES IN ONE OF THE
16
POSSIBLE COMBINATIONS LISTED BELOW
O
NCE AGAIN CLOSE THE REMOTE CONTROL COVER
R
EMOVE THE POWER SUPPLY TO THE REMOTE CONTROL BOX DISCONNECTING THE PLUG OR SHUTTING OFF POWER AT THE
GENERAL CUT
-
OUT SWITCH FOR THE AREA
R
ESUPPLY POWER AND WITHIN
5
SECONDS SIMULTANEOUSLY PRESS THE
AUTO
AND
“+”
BUTTONS FOR
3
SECONDS
(
YOU WILL
HEAR A BEEP SIGNIFYING THAT THE CODE HAS BEEN MODIFIED
)
THE WIRELESS CONTROL LIGHT DOES NOT TURN-ON:
Check the status of the wireless’s battery charge control.
In case of replacement proceed as follows: using a small Phillips-head screwdriver, remove the screws in the rear part
of the wireless control; then keeping it inverted, remove the rear shell. At this point replace it with a new, A 23 12V
type, taking care not to invert the polarity (battery type and polarity are in any case also described on the wireless
control chart visible in the photo above). Then close the wireless control and dispose of the old battery throwing it in
the special containers located in the supermarkets, collection centres ecological islands, etc.
If the problem persists, contact a vendor service center.
THE WIRELESS CONTROL FUNCTIONS BUT THE RECEIVER DOES NOT RESPOND:
If when pressing the wireless control light turns on but the receiver does not respond check that:
1.that electrical power plug is inserted in the electrical socket;
2.that the connectors are inserted properly;
3.the fuse in the wireless control box is in good condition, if necessary replace it with new one (T1.,6AL250V);
If the problem persists, contact a vendor service centre.
MICRO-SWITCHES
TRANSMISSION CHANNEL COMBINATIONS
1
2
3
4
TRASM.
1
2
3
2
1
4
3
1
2
3
4
4
3
2
1
4
8
1
2
3
7
3
2
1
4
4
TRASM.
5
6
1
2
3
3
2
1
4
4
4
3
2
1
12
1
11
4
2
3
9
1
1
10
4
4
2
3
3
2
TRASM.
14
13
15
16
1
2
3
4
3
2
1
4
2
3
3
2
1
1
4
4
TRASM.

Other manuals for Piazzetta Multifuoco 2003

Related product manuals