PicoBrew Zymatic - Setting Up Your Zymatic; 2.1 Zymatic Setup

SECTION 2: SETTING UP YOUR ZYMATIC
®
- CONTINUED
14 15
SECTION 2
Setting Up Your Zymatic
2.1 Zymatic Setup
A - On/Off switch
B - OLED display
C - Control knob (twist to scroll, press to select)
D - White nylon washers
E - Inline filter
F - OUT (black) hose connects to OUT post of keg,
controls flow into step filter
G - IN (gray) hose connects to IN post of keg, controls
flow into keg
H - Drip tray
I - Step filter
A
I
H
G
F
B C
D E
2.2 Zymatic Assembly
Set the Zymatic on a sturdy, level surface. Peel off any
remaining white protective film from all surfaces.
Insert the white nylon washers into the flare nut fittings on
the ends of each hose. This prevents the hoses from pumping
air or leaking.
1. Match the BLACK hose to the BLACK sticker and the
GRAY hose to the GRAY sticker.
GRAY
“IN hose”
← Front
BLACK
“OUT hose”
Back →
1
2