8
Customer support team: +44 (0) 333 220 6054
Oscillation:
1. This fan is equipped with an oscillation
function, for more even heat distribution
across a room or area.
2. Push the oscillation knob at the back
of the motor housing down to turn the
oscillation function on. The fan will
automatically begin pivoting from side to
side in a fixed pattern.
3. Pull the oscillation knob up while the fan
is oscillating to turn this function off. The
fan will automatically remain locked at its
current angle, and the wind flow will be
directed that way. To select a different
angle or direction for the wind, turn the
oscillation function back on, as described
above, wait until the fan is facing in
the required direction, then pull the
oscillation knob up to stop the oscillation
function and lock the fan into place.
Adjusting the Air Flow:
This unit is equipped with a vertical tilt
function, which can be manually adjusted to
better direct the air flow.
1. To adjust the vertical tilt angle of the
fan, firmly grip the top half of the motor
housing and push it gently upwards or
downwards as required. The fan will give
off a clicking noise to indicate the tilt
mechanism is working.
2. Once the fan has been tilted, it will
automatically remain at the selected
angle until manually adjusted again.
Cleaning and care:
1. Before cleaning always switch off the
appliance and remove the plug from the
electrical socket.
2. To clean the outside of the fan, wipe the
exterior with a soft, damp cloth.
3. Never use an abrasive cleaner.
4. When not in use, store the fan (preferably
in its original box) in a cool, clean and dry
location.
Cleaning the fan blades:
1. Remove the front guard by unclipping
the locking clips located around the
circumference of the guard. The top lock
does not unclip.
2. Use a small spanner to unscrew the nut
and bolt that holds the bottom of the
front guard to the back guard.
3. With both hands, pull the front guard
downwards and away.
4. Clean the fan blades with a soft, damp
cloth.
5. Slide the front guard back into place, so it
fits into the top lock clip. Clip all the locks
back into place and screw the nut and
bolt back in.
CAUTION:
Do not use the fan when the front guard
is not locked into place.
Note:
Make sure that the fan is on a level
surface and away from any liquids.
Oscillating the fan will create a more
uniform cooling effect in the room.
Note:
The fan’s horizontal angle cannot be
manually adjusted. To change the
horizontal angle of the fan, activate the
oscillation function as detailed above,
wait until the fan is at the desired angle,
then pull the oscillation knob up to stop
the oscillation function and lock the fan
into place.
To Next Page
Loading...
