1. Control LED
As long as a key is being pressed on the PIKO Digi remote control, the remote control
sends an infra red signal.
This activity is shown by the control LED.
2. Transmission channel
The PIKO Digi 1 uses 4 transmission channels for the controls. The transmission signal can
be altered at any time by pressing one of the keys .
The address of a loco to be driven can be allocated to each transmission channel inde-
pendently of the other channels.
In addition, 4 individual variable addresses for electromagnetic components can be allo-
cated in each channel to the 4 accessory keys. The addresses selected for each channel
are not however stored permanently and are reset as follows when the Digi 1 has been
switched off:
When the power is switched on the channels are always allocated to the loco
addresses 1, 2, 3 and 4 and the accessory keys in all channels control magnetic compo-
nent addresses 1 to 4.
Using the channel keys on the PIKO Digi remote control it is easy to change rapidly bet-
ween controlling 4 locomotives and 4 groups each consisting of 4 accessories.
If several PIKO Digi remote controls are used each PIKO Digi remote control can select a
different transmission channel and so control an individual loco without affecting the
loco driven from another PIKO Digi remote control using a different transmission chan-
nel.
3. Loco control
First of all the transmission channel A, B, C or D must be selected using the keys
3.1. Entering the loco address
A loco address must be selected.
To select a loco address press the loco key The desired loco address can then be
entered using the numerical keys 0 to 9
The entry is concluded when any other key is pressed.
This rule does not apply to the channel selection keys . For instance, the entry
can be terminated by pressing the key for lights control or a key for altering the speed of
the loco.
If on the other hand the loco key , is pressed after the figures have been entered the
selection mode is terminated without carrying out the command.
The selection mode is also terminated if no input is made within 10 seconds.
11
To Next Page
Loading...
