Operating Manual 21
Changes in the documentation
Changes from version I to version II
Old New Change
p. no. p. no.
22Description of the positive-switching outputs
66Description of the tests to be carried out by the user
on outputs that are excluded from the output test
10 10 Function of the LED “SB active”
15 15 How groups are displayed in the programming device
18 18 Information added on the on time during self test
Changes from version II to version III
Old New Change
p. no. p. no.
33The layout of the switch for setting the device address
was amended.
14 14 Procedure when adding a module to the bus structure
was amended.
Changes from version III to version IV
Old New Change
p. no. p. no.
33Labelling strip for inputs and outputs
4, 5, 12 4, 5, 12 If an error occurs, outputs are switched off first and then
the error telegram is sent.
66Category 2 in accordance with EN 954-1 can be
achieved using outputs excluded from the output test.
11 11 Installation using fixing bolts
17 17 Information on “Supply” amended
18 18 Information on test pulses amended
18 18 Length of off time during self test reduced (< 200 µs)
To Next Page
Loading...
