Need help?Do you have a question about the Pioneer A-229 and is the answer not in the manual?
General| Type | Integrated Amplifier |
|---|---|
| Frequency Response | 5 Hz - 100 kHz |
| Total Harmonic Distortion | 0.08% |
| Input Sensitivity | 2.5mV (MM), 150mV (line) |
| Weight | 5.5kg |
| Speaker load impedance | 4 ohms to 16 ohms |
| Dimensions | 420 mm x 125 mm x 282 mm |
| Signal to noise ratio | 74 dB (MM), 98 dB (line) |
| Signal-to-Noise Ratio | 74dB (MM), 98dB (line) |
Covers critical warnings for fire/shock hazards and important notices for specific regions.
Guide for setting the voltage selector switch on the rear panel to match local power requirements.
Details on preventing electric shock, not opening the enclosure, and safe usage near water.
Instructions for connecting the mains lead in the UK based on wire colours.
Guidance on properly grounding outdoor antennas for protection against surges and static.
Guidance on selecting a suitable location, avoiding heat, moisture, and ensuring ventilation.
Precautions for handling the power cord to prevent damage, fire, or electric shock.
Instructions on how to clean the unit's external surfaces without causing damage.
Illustrates the typical connections for various audio components to the amplifier.
Details on connecting speaker cords and recommended impedance ratings for speaker systems.
Instructions for connecting audio source components using RCA input/output cords.
Specific instructions for adjusting rear feet position for UK models for shallower placement.
Description of the power switch, input selector, and volume control on the front panel.
Explanation of the bass, treble, balance, and loudness controls and their functions.
Details on speaker selection switches and the headphone jack for private listening.
Identification and description of all input/output terminals and grounding posts on the rear panel.
Information on the switched and unswitched AC outlets and connecting the power cord.
Steps to follow before starting operations, including setting switches and controls.
How to select a playback source and begin listening to audio.
Instructions for recording audio onto tape and copying tapes between decks.
Guide on connecting and using external components like graphic equalizers or tape decks.
A table listing common symptoms, their potential causes, and remedies for troubleshooting.
Detailed technical specifications for the amplifier section, including power output and distortion.
Information on power requirements, unit dimensions, weight, and included accessories.
To Next Page
