Pioneer A-443 Operating Instructions

STEREO AMPLIFIER
A-443
A-333
- Operating
Instructions
The illustration shows mode! A-443.
Thank you for buying this Pioneer product.
Please read through these operating instructions so you will
know how to operate your model properly. After you have
finished reading the instructions, put them away in a safe
place for future reference.
In some countries or regions, the shape of the power plug
and power outlet may sometimes differ from that shown
in the explanatory drawings. However, the method of
connecting and operating the unit is the same.
WARNING: to prevent FIRE OR SHOCK
HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR
MOISTURE.
LINE VOLTAGE SELECTOR SWITCH
Only multi-voltage models are provided with this switch.
U.S., Canadian, European, U.K., and Australian models are
not provided with this switch.
Mains voltages in Saudi Arabia are 127V and 220V only.
Never use this model with 110V setting in Saudi Arabia.
The line voltage selector switch is on the rear panel. Before
IMPORTANT NOTICE
[FOR U.S. and Canadian models]
The serial number for this equipment is located on the rear
panel. Please write this serial number on your enclosed
warranty card and keep it in a secure area. This is for your
security.
{For Canadian model]
CAUTION: to prevent ELECTRIC SHOCK DO
NOT USE THIS (POLARIZED) PLUG WITH AN EXTENSION
CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE
BLADES CAN BE FULLY INSERTED TO PREVENT BLADE
EXPOSURE.
ATTENTION: pour prevenirn tes cHocs
ELECTRIQUES EN PAS UTILISER CETTE FICHE POLARISEE
AVEC UN PROLONGATEUR UNE PRISE DE COURANT OU
UNE AUTRE SORTIE DE COURANT, SAUF SI LES LAMES
PEUVENT ETRE INSEREES A FOND SANS EN LAISSER
AUCUNE PARTIE A DECOUVERT.
your model is shipped from the factory, this switch is set
to the power requirements of the destination. Check that
it is set properly before plugging the power cord into the
AC wall socket. If the voltage is not properly set or if you
move to an area where the voltage requirements differ,
adjust the selector switch as follows.
1. Use a medium-size screwdriver.
2. Insert the screwdriver into the groove on the voltage
selector, and adjust so that the tip of the arrow points
to the voltage value for your area.
VOLTAGE SELECTOR
= 1a7v HOY
1z0-127¥ HOV
wow z0¥
Medium-size screwdriver
@) PIONEER’
The future of sound and vision.

Pioneer A-443 Specifications

General

Power Output	45 W/ch (8 ohms)
Frequency Response	5Hz to 100kHz
Input Sensitivity	150mV (line)
Signal-to-Noise Ratio	90 dB
Output	Speaker A/B
Dimensions	420 x 130 x 340 mm