These are the basic steps necessary to operate
the radio. More advanced tuner operation is
explained starting on the next page.
Important
If you are using this unit in North, Central or
South America, reset the AM tuning step (see
Setting the AM tuning step on page 83).
1 Source icon
Shows which source has been selected.
2 Band indicator
Shows which band the radio is tuned to, AM
or FM.
3 Preset number indicator
Shows which preset has been selected.
4 Frequency indicator
Shows to which frequency the tuner is
tuned.
5 Preset list display
Shows the preset list.
6 Stereo (5) indicator
Shows that the frequency selected is being
broadcast in stereo.
7 LOC indicator
Shows when local seek tuning is on.
1 Touch the source icon and then touch
TUNER to select the tuner.
# When the source icon is not displayed, you
can display it by touching the screen.
2 Touch the screen to display the touch
panel keys.
3 Touch BAND to select a band.
Touch BAND repeatedly until the desired band
is displayed, FM1, FM2, FM3 for FM or AM.
4 To perform manual tuning, briefly
touch c or d.
The frequencies move up or down step by
step.
# You can also perform manual tuning by mov-
ing the joystick left or right.
5 To perform seek tuning, keep touching
c or d for about one second and release.
The tuner will scan the frequencies until a
broadcast strong enough for good reception is
found.
# You can cancel seek tuning by briefly touching
either c or d.
# If you keep touching c or d you can skip sta-
tions. Seek tuning starts as soon as you release
the key.
# You can also perform seek tuning by holding
the joystick left or right.
Note
If you do not use the touch panel keys within 30
seconds, they will be hidden automatically.
Tuner
En
25
Section
05
Tuner
To Next Page
Loading...
Need help?
General
