Parts supplied
When installing the antenna inside the vehicle (on the rear shelf)
Affix the metal sheet on as level a surface as possible where the GPS antenna faces the
window. Place the GPS antenna on the metal sheet. (The GPS antenna is fastened with its
magnet.)
Notes:
• When attaching the metal sheet, do not cut it into small pieces.
• Some models use window glass that does not allow signals from GPS satellites to pass
through. On such models, install the GPS antenna on the outside of the vehicle.
Metal Sheet
Peel off the protective sheet
on the rear.
GPS antenna
Make sure the surface is
free of moisture, dust,
grime, oil, etc., before
affixing the metal sheet.
Clamps
Use clamps to secure the
lead where necessary inside
the vehicle.
Note:
The metal sheet contains a
strong adhesive which may
leave a mark on the surface
if it is removed.
To Next Page
Loading...
