After Installing this Navigation System
1. Reconnecting the battery.
First, double-check that all connections are correct and that this product is installed cor-
rectly. Reassemble all vehicle components that you previously removed. Then reconnect
the negative (–) cable to the negative (–) terminal of the battery.
2. Start the engine.
3. Press the RESET button.
Press the RESET button on the navigation unit using a pointed object such as the tip of a pen.
4. Enter the following settings:
1. Install the program in the navigation system.
2. Make any necessary installation angle adjustments. (Refer to “Correcting the installation
angle” in the Operation Manual.)
3. Drive until the initialized sensors start operating normally.
4. Set the time and language.
Set the navigation system as explained in the Operation Manual.
After installing this navigation system, be sure to check at a safe place that the vehi-
cle is performing normally.
26
English
Español
Deutsch
Français
Italiano
Nederlands
To Next Page
Loading...
