Pioneer AVIC-F10BT - Appendix; Troubleshooting and Error Messages

AVIC-Z110BT/XN/UC
145
5 678
56
7
8
C
D
F
A
B
E
7. DISASSEMBLY
2
3
4
While the photograph shown is slightly different from this model in shape, the disassembly procedure is the same.
-
Removing the Monitor Assy (Fig.1, 2, 3)
Fig.1
Draw out the Monitor Assy
and then remove the two screws. (Fig.1)
The main body is put on the stand of
the height of about 3 cm. (Fig.2)
(If three CD cases are piled up,
it becomes the stand of the even number degree.)
Bring down the Monitor Assy forward,
remove it. (Fig.2)
When Monitor Assy is removed,
it is noted that the length of the Flexible PCB is short.
Disconnect the Flexible PCB
from the connector. (Fig.3)
Remove the two screws
and then remove Holder. (Fig.3)
Fig.2
Fig.3
1
1
1
About 3 cm
2
Flexible PCB
3
3
4
Monitor Assy
(CD cases)
Holder