Pioneer AVIC-S1 - Speed Limit Warning

User's manual AVIC-S1
- 102 - Speed Limit Warning
8.7.12 TMC Status
TMC Status This setting is only available if you use the AVIC-S1 in
connection with the optionally available TMC kit ND-TMC1.
If you are using the device with the TMC kit, the system uses the
current traffic reports and, if necessary, can dynamically change
the route, e.g. in order to avoid a jam.
With this setting you can establish whether the TMC symbol
should be shown on the map. Using the TMC symbol you can
obtain information regarding whether the TMC receiver is
currently receiving traffic information.
For more information on the TMC symbol, refer to chapter
"
Status displays" on page 64.
The current setting is shown on the button. Tap on the button in
order to change the setting.
Setting Meaning
Show The TMC symbol will be shown.
Hide The TMC symbol will not be shown.
You will find detailed information on the TMC functionality in
chapter "
Traffic Messages" on page 81.
8.8 Speed Limit Warning
Speed Limit Warning In the SPEED LIMIT WARNING settings window you specify
whether you should hear an acoustic warning if you exceed an
existing speed restriction or you can set how many km/h or mph
you may exceed the limit before the warning is sounded.
1. Tap on Speed Limit Warning.
The S
PEED LIMIT WARNING window opens.