Pioneer AVIC-S1 - Taking into Account Traffic Reports

User's manual AVIC-S1
- 74 - Showing the map during navigation
For detailed information regarding the settings mentioned above,
refer to chapter "
Displayed Information" on page 97.
Caution: The display of speed limits and the warnings should
you exceed the speed limit depend on the settings that you have
made in the settings windows D
ISPLAYED INFORMATION and SPEED
LIMIT WARNING.
Caution: The information in the map material can be incorrect
on account of sudden changes (construction sites etc.)!
The traffic situation and the current signposts have priority over
the information given by the navigation system.
5.4.1 Taking into account traffic reports
TMC Traffic messages
If your navigation device is being used with optional TMC kit
(ND-TMC1), the system can access current traffic reports and
can, if necessary, dynamically change the route in order, for
example, to avoid a traffic jam.
When the device is not being used with the TMC kit, the TMC
icon is not shown.
Note: Traffic messages concerning your route will only be
displayed if Dynamic Route is set as route type in the ROUTE
PREFERENCES setting (refer to Route Preferences, page 94).
If a traffic report is received during navigation and this concerns
one of the sections of road ahead of you, then the T
RAFFIC ON
ROUTE window opens. It gives you information about the traffic
disruption and about the road sections that are affected.
Tap on the Evade button if you would like to have another route
calculated in order to avoid this area.
- OR –
Tap on the Ignore button to ignore the report and continue on
the route.
The T
RAFFIC ON ROUTE window closes again.