Pioneer CLD-M301 User Manual

MULTI-PLAY CD CDV/LD PLAYER § acarfisee
EeGlePiee Be OTS.
CLD-M450
ca
CLD-M401
©
This
player
is
not
suitable
business
use.
CLD-M301
e@ CD ROM/CD graphic discs cannot be played with this
player.
Operating
Instructions
diss
LY’
DIGITAL
AUDIO
LASER
DISC
CLD-M301
— re OS
CLD-M450/CLD-M401
(The illustration shows CLD-M401)
Thank you for buying this Pioneer product.
Please read through these operating instructions so you
will know how to operate your model properly. After you
have finished reading the instructions, put them away in a
safe place for future reference.
In some countries or regions, the shape of the power plug
and power outlet may sometimes differ from that shown in
the explanatory drawings.
However, the method of
connecting and operating the unit is the same.
WARNING: To PREVENT FIRE OR SHOCK HAZARD,
DO NOT EXPOSE THIS APPLIANCE TO RAIN OR
MOISTURE.
IMPORTANT NOTICE
[For U.S. and Canadian models]
The serial number for this equipment is located on the rear panel.
Please write this serial number on your enclosed warranty card
and keep it in a secure area. This is for your security.
(For Canadian model]
CAUTION: To PREVENT ELECTRIC SHOCK DO NOT
USE THIS (POLARIZED) PLUG WITH AN EXTENSION
CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE
BLADES CAN BE FULLY INSERTED TO PREVENT BLADE
EXPOSURE.
ATTENTION: POUR PREVENIR LES CHOCS
ELECTRIQUES NE PAS UTILISER CETTE FICHE POLARISEE
AVEC UN. PROLONGATEUR, UNE PRISE DE COURANT
OU UNE AUTRE SORTIE DE COURANT, SAUF SI LES
LAMES PEUVENT ETRE INSEREES A FOND SANS EN
LAISSER AUCUNE PARTIE A DECOUVERT.
LINE VOLTAGE SELECTOR SWITCH
Only multi-voltage models are provided with this switch.
U.S., Canadian, European, U.K., and Australian models
are not provided with this switch.
The line voltage selector switch is located on the rear panel
of this player. Before your player is shipped from the factory,
the switch is set to the power requirements of the player's
destination. Check that it is set properly before plugging
the power cord into the outlet. If the voltage is not properly
set or if you move to an area where the voltage requirements
differ, adjust the selector switch as follows:
Use a medium-sized (flat blade) screwdriver. insert the tip
of the screwdriver into the groove of the selector switch
and turn it to set the player to the power voltage of your
area.
Set the selector so that
arrow points to power
voltage of your area
{Figure shows arrow
pointing to 110 volts.)
YQ PIONEER’
The Art of Entertainment

Pioneer CLD-M301 Specifications

General

Disc Capacity	1
Remote Control	Yes
Laserdisc Size	12-inch, 8-inch
CD Capacity	1
Laser Type	Semiconductor Laser
Number of Channels	2
Total Harmonic Distortion	0.003%
Output Voltage	2 V
Type	Laserdisc/CD player
Playback Formats	CD, Laserdisc
Audio Output	Analog
Frequency Response	4Hz - 20kHz