Pioneer PL-Z93 Operating Instructions

STEREO DOUBLE CASSETTE DECK AMPLIFIER
DC-Z93
FM/AM DIGITAL SYNTHESIZER TUNER
F-293/F-Z93L
STEREO TURNTABLE
PL-Z93
Operating
Instructions
Thank you for buying this PIONEER product.
Please read through these operating instructions so you will know how
to operate your model properly. After you have finished reading the
instructions, put them away in a safe place for future reference.
In some countries or regions, the shape of the power plug and power
outlet may sometimes differ from that shown in the explanatory
drawings. However, the method of connecting and operating the unit
is the same.
LINE VOLTAGE SELECTOR SWITCHES
Only multi-voltage models are provided with these switches. U.S.,_
Canadian, European, U.K., and Australian models are not provided
with this switch.
Mains voltages in Saudi Arabia are 127 V and 220 V only. Never use
this model with 110 V setting in Saudi Arabia.
Before your model is shipped from the factory, these switches are set
to the power requirements of the destination; nevertheless, you should
check that they are set properly before plugging the power cord into
the AC outlet.
1. Disconnect the power cord.
2. Use a medium-size screwdriver.
3. insert the screwdriver into the
groove on the voltage selectors and
adjust so that the tip of the arrow
points to the voltage value of your
area.
“This product complies with the Radio Interference require-
ments of the EC (European Community) Directive 87/308/EEC.”
WARNING: The apparatus shall not be exposed to \two VOLTAGE SELECTORS
dripping or splashing.
IMPORTANT 1
CAUTION
RISK OF ELECTRIC SHOCK
olen [eam el ay)
The lightning flash with arrowhead, within an equilateral
triangle, is intended to alert the user of the presence of
uninsulated ‘’dangerous voltage’’ within the product's
enclosure that may be of sufficient magnitude to constitute
a risk of electric shock to persons.
CAUTION:
TO PREVENT THE RISK OF ELECTRIC SHOCK, DO
NOT REMOVE COVER {OR BACK). NO USER-
SERVICEABLE PARTS INSIDE. REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL.
The exclamation point within an equilateral triangle is
intended to alert the user of the presence of important
operating and maintenance (servicing) instructions in
the literature accompanying the appliance.
IMPORTANT 2
If the apparatus is fitted with AC mains power outlet(s),
see REAR PANEL FACILITIES for convenient
connection of additional Hi-Fi component{s). Make al!
connections to the AC outlet(s) and the signal terminals
first. Connect the plug to the wall socket last, make
sure that the power switch is off.
FOR USE IN THE UNITED
KINGDOM
The wires in this mains lead are coloured in
accordance with the following code:
Blue: Neutral
Brown: Live
VY) PIONEER’
The future of sound and vision.
As the colours of the wires in the mains lead of this
apparatus may not correspond with the coloured
marking identifying the terminals in your plug proceed
as follows:
The wire which is coloured blue must be connected to
the terminal which is marked with the letter N or
coloured black.
The wire which is coloured brown must be connected
to the terminal which is marked with the letter L or
coloured red.
Equipment sold in the U.K. is not supplied with a power
plug.

Pioneer PL-Z93 Specifications

General

Drive System	Direct Drive
Speed	33 1/3, 45 rpm
Speeds	33 1/3, 45 RPM
Frequency Response	20 Hz - 20 kHz
Signal-to-noise ratio	70 dB
Power Requirements	AC 120V, 60Hz
Cartridge Type	Moving Magnet
Platter	Aluminum
Output Level	2.5 mV
Type	Fully-Automatic Stereo Turntable
Tonearm Type	Static Balance S-shaped Tonearm
Tonearm	Static Balance S-shaped Tonearm