Need help?Do you have a question about the Pioneer QA-800A and is the answer not in the manual?
Details output power, distortion, and frequency response of the power amp section.
Outlines input sensitivity, distortion, and frequency response of the preamp section.
Describes the operation of controls like volume, bass, treble, filters, and loudness.
Detailed schematic of the head amplifier unit.
Detailed schematic of the control amplifier unit.
Detailed schematic of the main amplifier unit.
Detailed schematic of the decoder unit.
Detailed schematic of the logic unit.
Detailed schematic of the power supply unit.
Details output power, distortion, and frequency response of the power amp section.
Outlines input sensitivity, distortion, and frequency response of the preamp section.
Describes the operation of controls like volume, bass, treble, filters, and loudness.
Detailed schematic of the head amplifier unit.
Detailed schematic of the control amplifier unit.
Detailed schematic of the main amplifier unit.
Detailed schematic of the decoder unit.
Detailed schematic of the logic unit.
Detailed schematic of the power supply unit.
General| Power output | 40W/ch (8 Ohms, 1kHz) |
|---|---|
| Frequency response | 15Hz to 50kHz |
| Total harmonic distortion | 0.5% |
| Input sensitivity | 2.5mV (mic), 2.5mV (phono), 150mV (line) |
| Signal to noise ratio | 65dB (mic), 70dB (phono), 90dB (line) |
| Dimensions | 430 x 148 x 347mm |
| Weight | 12.8kg |
| Speaker load impedance | 4 Ohms to 16 Ohms |
To Next Page
