Pioneer S-DVR9SW - Specifications; General Specifications; Amplifier Section Specifications; Powered Subwoofer Specifications

S-DVR9SW
5
5 678
56
7
8
C
D
F
A
B
E
1. SPECIFICATIONS
General
Power requirements . . . . . . . . . . . . . . . 220–240 V, 50/60 Hz
Power consumption
S-DVR9SW . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 151 W
Power consumption in standby
S-DVR9SW . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0 W
Amplifier section
Continuous Power Output (RMS):
Front, Center, Surround . . . . . . . . . . .100 W per channel
(1 kHz, 10 % T.H.D., 6 Ω)
Subwoofer . . . . . . . . . . 100 W (100 Hz, 10 % T.H.D., 6 Ω)
Powered subwoofer (S-DVR9SW)
Enclosure . . . . . . . . . . . . . . . . . . . . . . . .Bass-reflex floor type
(magnetically shielded)
System . . . . . . . . . . . . . . . . . . . . . . . . . . 18 cm 1-way system
Speaker . . . . . . . . . . . . . . . . . . . . . . . . . . . 18 cm (cone type)
Nominal impedance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Ω
Frequency range . . . . . . . . . . . . . . . . . . . . 25 Hz to 2300 Hz
Maximum Input Power . . . . . . . . . . . . . . . . . . . . . . . . . 100 W
Dimensions . . . . . . . . . . . . .192 (W) x 395 (H) x 436 (D) mm
Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12.5 kg
Note: The specifications and design of this product are subject
to change without notice, due to improvement.