Pioneer S-HTD520 User Manual

Setting Up and Getting Started with your HTD52ODV
Check that you have all the accessories, then put
the batteries in the remote control.
Connect the DVD Receiver to your TV, then
connect the supplied power cord.
Connect the other end to the
video wtput of the DVD receiver.
Connect the power cord
to the AC inlet.
Switch on your TV and set it to
correct video input.
Connect each speaker as shown below.
Twist and pull off the
Connect one end to the DVD
receiver. Match the colored
wire with the color-coded
label (above the tabs), then
insert the colored wire into
the red (+) tab and the other
wire with the black (-) tab.
Playing DVDs and CDs.
.%.
For the best surround sound, setup your
speakers like this. The front left and right
speakers should be about 6-9 feet apart.
Front right
Many DVD discs have menus from which you can
choose from.
For detailed instructions, see the Operating Instructions supplied and / or contact one of our knowledgeable Pioneer Customer Service Representatives at 1 - (800) 421-1404.
Specifications and design subjected to modification without notice.

Pioneer S-HTD520 Specifications

General

Channels	5.1
Input Sensitivity	200 mV
Type	Receiver
Surround Sound Formats	Dolby Digital, DTS
Power Output	100W per channel (6 ohms, 1 kHz, 1% THD)
Speaker Impedance	6 ohms

Summary

Setting Up and Getting Started

Initial Setup Steps

Basic steps for connecting and powering on the system, and initial disc playback.

Safety and Warning Information

General Safety Precautions

Crucial warnings regarding electrical safety, water exposure, and general product handling.

Important Safety Instructions

Operational and Installation Safety

Guidelines for safe operation, installation, and maintenance of the equipment.

Hazard and Servicing Precautions

Warnings about electrical hazards, servicing procedures, and authorized parts.

Introduction and Features

Product Overview and Setup Navigator

Connecting the System

Speaker Connection and Placement

Step-by-step instructions for connecting speakers and guidelines for optimal placement.

Audio and Video Connections

TV and Component Connectivity

Connecting the system to your TV and other external audio/video components.

Power Connection

Power Connection

Connecting the power cord to the unit and a power outlet.

Controls and Displays

Front Panel Controls and Display

Remote Control Layout and Operation

System Setup and Configuration

Clock and Timer Setup

Setting the system clock and preparing for timer features.

Surround Sound Configuration

Adjusting speaker distances and balancing levels for optimal surround sound.

Advanced Setup Features

Setup Navigator Guide

Step-by-step guide for using the on-screen Setup Navigator.

Disc Playback Operations

Basic Disc Playback and Navigation

Fundamental controls for playing discs and navigating menus.

Radio Tuning and Disc Exchange

Sound Adjustment and Modes

Bass, Treble, P.Bass, and Sound Modes

Adjusting sound characteristics, selecting sound modes, and applying DSP effects.

Low Volume Surround and Direct Recording

Low Volume Surround and Direct Recording

Advanced Disc Operations

Disc Content Search and DVD Features

Audio Channels, Programming, and Random Play

Advanced Sound Configuration

LFE, Dynamic Range, and Dual-Mono Settings

Channel Volume Level Adjustment

DVD Setup Menu

DVD Setup Menu Navigation and Video Settings

Still Picture, Display, and Angle Settings

Language and Subtitle Configuration

Parental Lock and Screen Settings

Care and Maintenance

System and Disc Care Guidelines

Troubleshooting

Common Operational Issues

Solutions for common problems encountered during operation.

System Reset and Demo Mode

System Reset and Demo Mode