EasyManua.ls Logo

Pioneer SC-LX501 - Rear Panel

Pioneer SC-LX501
99 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
30
> Before start > Hookup > Setup > Playback >Part Names > Advanced Manual
Troubleshooting | Appendix
Rear Panel
1. COMPONENT VIDEO IN jacks: Input the video signals
from AV components with a component video cable.
2. ZONE 2 PRE/LINE OUT jacks: Output audio signals with
an analog audio cable to a pre-main amplifier or a power
amplifier in a separate room (ZONE 2). (
P18)
3. AUDIO IN jacks: Input the audio signal from AV
components with an analog audio cable.
4. VIDEO IN jacks: Input the video signals from AV
components with an analog video cable.
5. HDMI IN jacks: Transmit video signals and audio signals
with a HDMI cable connected to an AV component.
6. SIGNAL GND terminal: The ground wire of the turntable
is connected.
7. HDMI OUT jacks: Transmit video signals and audio
signals with a HDMI cable connected to a monitor such
as a TV or projector.
8. NETWORK port: Connect to the network with an
Ethernet cable.
9. DIGITAL AUDIO IN OPTICAL/COAXIAL jacks: Input the
digital audio signals from TV or AV components with a
digital optical cable or digital coaxial cable.
10.
Wireless antenna: Used upright for Wi-Fi connection or
when using a BLUETOOTH enabled device. The
diagram shows the movable range for the wireless
antenna. Do not try to force it beyond this range
otherwise you may break it.
11.
AC IN: The supplied power cord is connected.
12.
RS-232C port: For connection to the home control
system.
13.
ANTENNA AM LOOP/FM UNBAL 75Ω terminal: The
supplied antennas are connected.
14.
IR IN/OUT port: Allows you to connect a multiroom
remote control kit.
15.
12V TRIGGER OUT A/B jacks: Allows you to connect a
device with 12V trigger input jack to enable link operation
between the device and the unit.
16.
SUBWOOFER PRE OUT jacks: Connect a powered
subwoofer with a subwoofer cable. Up to two powered
subwoofers can be connected. The same signal is output
from each of the SUBWOOFER PRE OUT jacks.
17.
SPEAKERS terminals: Connect speakers with speaker
cables.
(North American models are compatible with
banana plugs.)
1 4
3
57268
1716
910 11
12
14 15
13
10

Other manuals for Pioneer SC-LX501

Related product manuals