FL Display LED flashes Status Timing (sec.) Description Remarks
(1) Over Current NA
When the overload USB
device (over 500 mA) is
connected.
Warning indication for
HDMI Simplay
Flashes 5 seconds
The connected USB device is overload.
The 12V trigger circuit is short-circuited, and a overcurrent is
generated.
(2) HDCP ERROR NA
When an HDCP ERROR
is detected.
Flashes
(3) 12V TRG ERR NA
When the 12V trigger
circuit is short-circuited.
The Icon “OVER”
lights
(4) NANA
When the ANALOG INPUT
OVER is detected.
When the B REG power
supply failure is detected.
Icon lights 1 second
While the Icon lights 1 second, when the ANALOG INPUT
OVER is detected again, the Icon continues to light 1 second
more from that time.
While the Icon lights 1 second, when there is no ANALOG
INPUT OVER detection, the Icon stops lighting and returns to
normal display.
(5)
ADVANCED
MCACC
NA
If abnormarlity voltage is detected in the B REG power supply
circuit(XBERR), the unit power off immediately and the
MCACC LED starts flashing.
To restore the previous status, follow the procedure “How to
Enter Release Mode”.
[3] Error Indications
(6) NA
When BT Adapter is not
connected.
Lights
While the ADAPTER PORT function is selected, the BT Adapter
is not connected.
NO ADAPTER
(7) NA
Non-BT Adapter is
connected.
Lights
While the ADAPTER PORT function is selected, the non-BT
Adapter is connected.
NOT AVAILABLE
(8)NA
No wireless connection
between BT source and
AVR
Lights
While the ADAPTER PORT function is selected, there is no
wireless connection between BT source equipment and AVR.
WAITING DEVICE
(9) NA
When overcurrent is
detected in the Adapter port.
Lights
While the ADAPTER PORT function is selected, overcurrent is
detected in the Adapter port, and Bluetooth function is not
available.
ADP OVERLOAD
WLAN POW ERR
(10)
NA
When power abnormality of
wireless LAN converter is
detected.
Flashes
Over-current status is generated at the power terminal of
wireless LAN converter.
To Next Page
Loading...
