Advanced Setup
90
En
Re-Equalization
Re-Equalization is a built-in feature of THX technology (see p.93) and is thus always in use for HOME THX
modes. If you want to apply this feature to other listening modes complete the steps below. Whether this
setting will benefit you or not depends on the type of room you have and your individual listening tastes.
1
2
4.3 . Re-Equalization
HOME THX :ON
except THX MUSICMODE
STANDARD [OFF]
STEREO [OFF]
Multi-Ch Input [OFF]
[Return]
4.THX Audio Setup
[ 1.Ultra2 SW Setup ]
[ 2.SurBack Sp Position ]
[ 3.Re-Equalization ]
[Return]
4.3. Re-Equalization
HOME THX :ON
except THX MUSICMODE
STANDARD [ON]
STEREO [OFF]
Multi-Ch Input [OFF]
[Return]
4.3. Re-Equalization
HOME THX :ON
except THX MUSICMODE
STANDARD [ON]
STEREO [OFF]
Multi-Ch Input [OFF]
[Return]
System Setup
[Auto Surround Setup]
[1. Input Assign ]
[2. Surround Setup ]
[3. Expert Setup ]
[4. THX Audio Setup ]
[Exit]
3
4
5
Follow steps 1-4 on page 88, if necessary, to get to
the starting point mentioned here.
1
RE-EQUALIZATION should be
selected if it isn’t use the 5∞
buttons to select it.
2
Use the ∞5 buttons to select the
STANDARD, STEREO, or MULTI-CH
INPUT settings.
You should choose the listening mode that you would
use for listening to movies or other sources that
would generally be played in a large theater.
3
Use the 23 buttons to select ON
for the mode(s) you specified above.
Selecting STANDARD ON will also apply
Re-Equalization to the ADVANCED CINEMA listening
modes.
4
Select RETURN (use ∞5) to go back
to the THX AUDIO SETUP menu and
press ENTER.
5
If you want to finish THX AUDIO
SETUP use the 5∞ buttons to select
RETURN and press ENTER. Then
use the 5∞ buttons to select EXIT
and press ENTER.
ENTER
STANDBY/ON
5˜∞˜2˜3˜ENTER buttons
memo
If you set this function on the amplifier cannot do
96kHz processing.
To Next Page
Loading...
Need help?
General