Pioneer VSX-AX3-S User Manual (English)

Other manuals for Pioneer VSX-AX3-S

Questions and Answers:

M
Mrs. Veronica HernandezAug 27, 2025
Why is there no sound output from the subwoofer of my Pioneer Receiver?
- C
  Charles SimonAug 27, 2025
  Check these settings: * Ensure the subwoofer setting is set to YES or PLUS. * Adjust the subwoofer output setting to your desired level. * Adjust the bass peak level setting to your desired level. * Change your subwoofer setting to Front: SMALL Subwoofer:YES or Front:LARGE Subwoofer:PLUS if there is very little low frequency information in your source. * Raise the crossover frequency to match your speakers’ characteristics. * Check the power, volume control, and standby mode on the subwoofer itself. * Ensure the subwoofer is properly connected.
B
brownkyleAug 27, 2025
Why is there no image output when a function is selected on my Pioneer VSX-AX3-S Receiver?
- T
  Todd GarrisonAug 27, 2025
  Check that the component is connected correctly and that you have selected the correct function button. Also, ensure the video input selected on the TV monitor is correct, consulting your TV monitor manual if needed. Verify that the same type of cable is used to connect the TV and all your video equipment.
L
Lauren HernandezAug 26, 2025
What to do if my Pioneer Receiver is not responding when the buttons are pressed?
- D
  donaldfrazierAug 26, 2025
  Static electricity caused by dry air may be the reason. Try switching the unit off, then on again. If that doesn't work, disconnect the power plug from the outlet, and then plug it back in.
S
Scott ValdezAug 25, 2025
How to fix considerable noise in radio broadcasts on Pioneer Receiver?
- S
  staffordzacharyAug 26, 2025
  First, tune in the correct frequency. Then, ensure the antenna is properly connected. Also, route digital cables away from the antenna terminals and wires, as they may cause interference.
S
Sean SandersAug 25, 2025
What to do if there is no sound output when a function is selected on my Pioneer VSX-AX3-S?
- J
  Jeffrey MooreAug 25, 2025
  Check the following: * Ensure all components/speakers are connected correctly. * Press MUTING on the remote control to unmute. * Adjust MASTER VOLUME to increase the volume. * Press SPEAKERS (A/B) to select the connected speakers. * Select the proper signal with the SIGNAL SELECT button. * Turn MULTI CH IN mode off.