Add Contact Phone Numbers
Press PROGRAM key on console. Enter the default password 888 888. Use scroll key to select Phone Numbers, press
Enter, you will see below list
Add Select Add press Enter. You will see Input phone number, direct input your area code and phone number, press save.
You can add maximum of 6 numbers for emergency contact if the system is triggered. It is recommended to add your
cell phone and your family or friends’ numbers. DO NOT add 911 or the local police number directly unless you get a
permit.
Edit select Edit press Enter, you will see Phone#1, Phone#2… select the target number which you want to edit, then press
Enter, you will see Auto login, press Enter, If you set Auto login as Yes, then you can remotely call the system
telephone number from anywhere in the world, you do not need to enter the password again to save you time when
entering system remotely. It is recommended to set only your own number as auto login, all other numbers, keeps
default as No.
Delete Select Delete then press Enter, you will see all numbers which you saved, choose the target number which you
want to delete then press Enter and delete it.
SMS Numbers
This system can store 3 text message receiving cell phone numbers. When alarming, it will send text to all these numbers
e.g. power outage or any sensor triggered, you will get notification by text message.
Press PROGRAM key on console. Enter the default password 888 888. Use scroll key to select SMS Numbers, press
Enter, you will see below list
Add select Add press Enter. You will see Input phone number, direct input your area code and cell phone number. press
save. You can add maximum of 3 numbers for receive text message
EditSelect Edit press Enter,you will see Phone#1, Phone#2… select the target number which you want to edit, then press
Enter, you will see Auto password. If you set Auto password as Yes, then you can remotely text the system
telephone number from anywhere in the world, you do not need to enter the password again to save you time when
arm/disarm system remotely. It is recommended to set only your own number as auto login, all other numbers, keep
default as No.
Delete Select Delete then press Enter, you will see all numbers which you saved, choose the target number which you
want to delete then press Enter and delete it.
Arm/Disarm Notification Select Arm/Disarm Notification then press Enter, if you check Yes, you will get a text message
notification during system ARM or DISARM time, default is NO.
Outgoing Message
Press PROGRAM key on console and enter the default password 888 888. Use scroll key to select Outgoing Messages,
press Enter, you will see below list
Edit Text Message press Enter you can directly input a text message for outgoing.
Record Voice Message Select it and press Enter, select Record, and press Enter. You will see “Recording”and a
counter from 10 to 00. When you see 10, you need to immediately start recording your voice and stop when you see 00.
It is recommended that you record your home address for the outgoing message.
Play You can select Play to play your voice. If you do not like it, you can Delete it and Record it again until you are satisfied.
Note: The closer you are to the console during recording, the better the quality of the recording. Your mouth should be
no more than 2 inches away from the console.
To Next Page
Loading...
