Door/Window Open Reminder Select it and press Enter, If you set it Yes, you are not able to arm your system normally
when doors or windows are open. It will remind you which zone door or window is open. You must close it, unless you
arm the system by pressing button and holding for 3 seconds to force system to be armed. The default is set to
NO.(This function will not work with updating system GSM06)
Note: this function only work when you use remote keychain arm your system, you still can press Arm key input
password on the console without this reminder warning.
Date/Time Allows you to manually set your local date and time
Priority Dial Telephone When you connect your console with dual network Landline and GSM both, then you may need
to highlight “Priority Dial Telephone” press Enter and highlight “Yes” then Save it, this function allows you to set your
system and use your landline priority to call out and save your SIM card credit, if someone cuts your landline the system
will automatically call out from your SIM card. If you only use SIM card, please set it as NO.
Language English
Factory Reset<Restore Defaults> Allows you to set all functions as default without deleting your sensors and sirens so
you do not need re-program again. If you choose<Format System>, it will go back to factory default and format all your
settings including your sensors and sirens. Then you will need to re-program all sensors, sirens and remotes to the
console again. Beware of this function.
About System
Version press Enter you will find your software version
Production Date: press Enter you will see the producing time of your system
Manufacture By Pisector Inc.
IMEI: press Enter you can find IMEI number for your system, maybe request to active your SIM card
Remotely Control Your Home Security Alarm System
Dial the number of the main unit console panel by your cell phone, and after 1 ring, you will hear a voice prompt “Please enter
password”. If the password is correct, you will then hear a voice prompt “Please enter instruction" then you can press 1 to arm,
Press 2 to disarm, Press 3 to monitor, or Press 4 to intercom. If the password is incorrect, you will hear a prompt voice
“Wrong password, please re-enter”.
The system default operate password is 888888. Make sure to enter the password firmly by pressing and holding one digit at a
time so you can hear a beep for each key press. You may need to hold keys for half a second at a time.
Press [1]: arm, if finished successfully, you will hear a voice prompt “System armed”.
Press [2]: disarm, if finished successfully, you will hear a voice prompt “System disarmed”.
Press [3]: monitoring for 30 seconds, to continue monitoring, press [3] again for another 30 seconds. You can cancel monitoring
at anytime by pressing [1] to arm and [2] to disarm.
Press [4]: two-way intercom for 30 seconds. You cannot operate the main unit console panel during this time. You can cancel
intercom at anytime by pressing [1] to arm and [2] to disarm.
Or just simple text message from you cell phone to Arm/Disarm/Home Arm/History checking it
Password follow by 1 for Arm. i.g 888881 Password follow by 2 for Disarm. i.g 8888882,
Password follow by 3 for Home Arm, I.g 8888883 Password follow by 4 for History checking. i.g 8888884.
Answer Alarm Call: to prevent alarm call answered by voice mail, you need manually answer the incoming alarm on your
pre-saved cell phone then press # # twice to stop call the second number.
To Next Page
Loading...
