alarm status, use for door only)
Delayed Zone Highlight it press Enter, Default is NO, (if set YES, allows you to come back home and open the door without
triggering the system. System default delay alarm time is 45 seconds. You can change this time by going to "System Settings" and set
the Alarm Delay time).
Siren Enable Highlight it press Enter, Default is YES, (if set NO, siren will disable when this zone triggered, no siren alarm will
sound.)
Note: All zones are instant zones by Default.(“Instant “refers to the system being immediately armed if any zone is triggered
when the system is in armed status.)
Delete select it then press Enter, you can find the target sensor and delete it, you can delete any sensor from console
panel.
NOTE: After programming all sensors to your console, please test each sensor before you mount the sensor to the
appropriate location. DO NOT close the door fast then one second during testing, open door and waiting 1-2 seconds when
you see sensor light off then close the door, otherwise the console may only receive door open signal and not detect the door
close signal then shows the door is opening on LCD screen.
Place each sensor in the appropriate location.
Note: If possible, place the bracket on the stationary frame
of door or window, and place the magnet on the door or
window itself. You may apply super glue on the surface
of window/door before use 3M tape stick.
Various orientations between the Bracket and Magnet may
be used as long as 3/4" distance is not exceeded. See
Example in Figures 1-4
NOTE: SPACERS IN BOTTOM TRAY MAY BE USED ON THE BRACKET OR MAGNET TO ADJUST ALIGNMENT
Once you have determined the appropriate location and orientation for the Bracket and Magnet, attach them with double-sided
tape (the Magnet Space and Bracket Space are optional; only apply when your door/window gap is big or very low)
To Next Page
Loading...
