EasyManua.ls Logo

Pit Boss 71340 - User Manual

Pit Boss 71340
31 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
the ULTIMATE 8-in-1 GRILL
Proposton 65 Wrnn
Combuston b-products produced when usn ths product contn
chemcls nown to the Stte of Clforn to cuse cncer, brth
defects, nd other reproductve hrm Ths product contns chemcls
nown to the Stte of Clforn to cuse cncer, brth defects or other
reproductve hrm Wsh hnds fter hndln ths product
WARNING: Please read the entire manual before installation and
use of this electric, pellet fuel burning appliance. Failure to follow
these instructions could result in property damage, bodily injury or
even death. Contact local building or fire officials about restrictions and
installation inspection requirements in your area.
  . 
 ,
 ,   
 340
 71340
SAVE THESE
INSTRUCTIONS!
MANUAL MUST BE READ
BEFORE OPERATING!
WOOD PELLET
GRILL & SMOKER
  

Table of Contents

Questions and Answers

  • E
    Emily CalderonAug 17, 2025
    Why is my Pit Boss 71340 Grill producing too much smoke or discolored smoke?
    • H
      Hannah ValenciaAug 17, 2025
      Excessive or discolored smoke from your Pit Boss grill can be due to a few reasons. Grease build-up can cause this, so follow the care and maintenance instructions. Another cause could be the wood pellet quality; remove any moist pellets and replace them with dry ones after cleaning out the grill. Lastly, a blocked burn pot can contribute to this issue, so clear the burn pot of any moist wood pellets.
  • K
    Kimberly CortezAug 20, 2025
    How to lower the temperature on the SMOKE setting of my Pit Boss 71340?
    • S
      Shaun KellyAug 20, 2025
      If the grill temperature on the SMOKE setting is too high on your Pit Boss grill, the "P" setting might be too low. To adjust this, turn the temperature dial to SMOKE, push the "P" SET button, and increase the "P" setting. Keep in mind that after preheating at high heat, the auger will continuously feed pellets for four minutes, raising the temperature temporarily. It will stabilize once the "P" setting cycle begins (approximately five to ten minutes).
  • R
    Roger CunninghamAug 22, 2025
    Why won't the LCD screen light up on my Pit Boss Grill?
    • K
      Kimberly GreerAug 22, 2025
      There are several reasons why the LCD screen on your Pit Boss grill might not be lighting up. First, ensure the grill is properly plugged into a working power source. Also, check that all wire connections are firmly connected. Another possible cause is a blown fuse on the circuit board, which would need to be replaced. The GFCI outlet may have been tripped, so ensure it's a minimum 10 Amp service and the wire connections are dry. Finally, make sure the temperature dial is not in the OFF position; turn it to SMOKE to start the unit.
  • P
    pwagnerAug 25, 2025
    What to do if the fire in the burn pot of my Pit Boss 71340 will not light?
    • A
      Ashley MayerAug 26, 2025
      If the fire in the burn pot of your Pit Boss grill won't light, several factors could be the cause. The auger may not be primed, which is necessary before the first use or after the hopper has been completely emptied. Follow the Hopper Priming Procedure. Alternatively, the auger motor might be jammed. Inspect the auger feed system and motor rotation. If the motor is not operating properly or the bracket is damaged, contact Customer Service for a replacement part. Lastly, the igniter may have failed and needs replacement. In the meantime, you can use the Manual Start-up Procedure.
  • J
    James GonzalezAug 28, 2025
    How to fix a Pit Boss 71340 Grill that will not maintain a stable temperature?
    • J
      Julia EllisAug 28, 2025
      If your Pit Boss grill isn't maintaining a stable temperature, consider these potential causes: Adjust the control settings by lowering the "P" setting to decrease temperature fluctuations. Ensure sufficient airflow through the burn pot by checking for ash build-up or obstructions, verifying the fan is working correctly and the air intake isn't blocked, and confirming the auger motor's operation without blockages. Make sure there is sufficient and good quality fuel. Also, inspect the grill temperature probe for dirt. Once these steps are done, start the grill, set the temperature to SMOKE, wait 10 minutes, and check that the flame is bright and vibrant.
  • C
    crystal25Aug 30, 2025
    What does the "ErH" error message mean on my Pit Boss 71340 and how to fix it?
    • D
      Donald PotterAug 30, 2025
      The "ErH" error message on your Pit Boss grill indicates that the grill has overheated, possibly due to a grease fire or excess fuel. To resolve this, turn the temperature dial to OFF and allow the grill to cool. Remove the pellets and confirm the correct positioning of all component parts after maintenance. To clear the error, turn the temperature dial to OFF, open the lid, wait 3 to 4 minutes, then select your desired temperature.
  • S
    sarahyoungSep 2, 2025
    Why is the temperature flashing on the LCD screen of my Pit Boss Grill?
    • C
      Christine DuranSep 2, 2025
      A flashing temperature on the LCD screen of your Pit Boss grill indicates that the grill temperature is below 65°C / 150°F. This suggests a risk that the fire could go out. Check the hopper for enough fuel and any feed system obstructions. Also, inspect the grill temperature probe for dirt, the burn pot for ash build-up, and ensure the fan is working with unblocked air intake. Finally, check the auger motor for proper operation and any tube blockages.
  • H
    hunterpatelSep 5, 2025
    What does "ErP" mean on a Pit Boss 71340 Grill?
    • A
      Amanda JohnsonSep 5, 2025
      The "ErP" error message on your Pit Boss grill can occur if the temperature dial wasn't in the OFF position when last connected to AC power. To fix this, turn the temperature dial to OFF, wait two minutes, and then turn the unit back on to SMOKE or your desired temperature. This safety feature prevents an inadvertent start. This error can also appear if a power outage occurred while in operation, but there is no suggested solution to fix this.
  • V
    victoria77Sep 8, 2025
    What does the “Err” error message mean on my Pit Boss grill?
    • D
      dustin69Sep 8, 2025
      The “Err” error message on your Pit Boss grill indicates that the temperature probe wire is not making a connection. Check the hopper access panel for any damage. Ensure the probe wire connections are firmly connected and correctly attached to the digital control board.
  • M
    Mary BryantSep 12, 2025
    How to prevent frequent flare-ups on my Pit Boss 71340?
    • M
      meganrussellSep 12, 2025
      To prevent frequent flare-ups on your Pit Boss grill, try cooking at a lower temperature. Grease has a flash point, so keeping the temperature under 176°C / 350°F when cooking greasy foods can help.

Summary

Safety Information

Dangers and Warnings

Key safety warnings and precautions for operating the wood pellet grill.

Disposal of Ashes

Proper procedures for disposing of grill ashes safely.

Wood Pellet Fuel Guidelines

Guidelines and information on using appropriate wood pellet fuel.

Carbon Monoxide Hazards

Information on the dangers and symptoms of carbon monoxide poisoning.

Safety Certifications

Details on product safety certifications and compliance standards.

Parts and Specifications

Component Identification

Visual guide and list of all grill components with part numbers.

Product Specifications

Details on model, dimensions, weight, cooking area, and temperature range.

Assembly Instructions

Assembly Preparation

Steps to take before assembling the grill, including inspection.

Main Barrel and Leg Assembly

Detailed steps for attaching legs and wheels to the main grill barrel.

Hopper and Lid Assembly

Guide for attaching the hopper assembly and lid handle to the grill.

Cooking Components Installation

Instructions for placing the grease bucket, cooking grids, and flame diffuser.

Power Connection

Guidance on connecting the grill to a power source, including GFCI outlets.

Operating Procedures

General Operating Guidelines

General instructions for operating the wood pellet grill.

Environmental Considerations

Recommendations for grill placement and operation in various weather conditions.

Grill Temperature Settings

Explanation of different temperature ranges and their uses.

Control Board Functionality

Explanation of the grill's control panel features, settings, and error messages.

P Setting Explanation

Explanation of the "P" setting for fine-tuning grill performance and smoke flavor.

Hopper Priming Procedure

Steps for priming the pellet hopper before initial use or after emptying.

Grill Burn-Off and Preheating

Procedures for initial burn-off and preheating before cooking sessions.

Automatic Start-Up Procedure

Step-by-step guide for starting the grill using the automatic igniter system.

Igniter Failure Procedure

Troubleshooting steps if the electric igniter fails to work.

Manual Start-Up Procedure

Alternative method for starting the grill without the electric igniter.

Shutting Down the Grill

Proper procedure for turning off and cooling down the grill after use.

Maintenance and Cooking

Care and Maintenance Schedule

Recommended cleaning and maintenance procedures for the grill components.

Wood Pellet Fuel Usage

Guidelines for selecting, storing, and using wood pellet fuel for optimal results.

Cooking Guidelines and Tips

Advice on achieving desired cooking results and helpful grilling techniques.

Troubleshooting and Electrical

Troubleshooting Common Problems

Solutions for common operational issues encountered with the grill.

Electrical Wire Diagram

Visual representation of the grill's electrical components and connections.

Parts, Warranty, and Service

Replacement Parts Catalog

List of available parts for ordering and replacement.

Limited Warranty Information

Details of the limited warranty coverage for Pit Boss grills.

Ordering Parts and Customer Service

Information on how to order parts and contact customer support.

Recipes

Grilling Recipes Collection

A variety of recipes designed for use with the Pit Boss grill.

Pit Boss 71340 Specifications

General IconGeneral
BrandPit Boss
Model71340
CategoryGrill
LanguageEnglish

Related product manuals