8
1.
Parts Required:
1 x Hot Plate
(#1)
1 x Fire Box
(#2)
4 x Fire Box Feet
(#6)
Installation:
• Carefully, lift and remove the Hot
Plate from the Fire Box.
• Next, tip the Fire Box onto its side,
exposing the bottom of the unit.
Install the Fire Box Feet by rotating
into the hole at each of the four
corners.
• Once all four Fire Box Feet are
installed, turn the unit upright and
replace the Hot Plate into position
on top of the Fire Box.
Parts are located throughout the shipping carton, including underneath the griddle.
Inspect the unit, parts, and hardware blister pack after removing from the protective
shipping carton. Discard all packaging materials from inside and outside of the griddle
before assembly, then review and inspect all parts by referencing the parts list. If any
part is missing or damaged, do not attempt to assemble. Shipping damage is not
covered under warranty. Contact your dealer or Pit Boss® Grills Customer Service for
parts: Monday through Sunday, 4am - 8pm PST (EN/FR/ES).
service@pitboss-grills.com
Toll-Free: 1-877-303-3134 | Toll-Free Fax: 1-877-303-3135
Tools required for assembly: screwdriver.
Tool not included.
To Next Page
Loading...
Need help?
General
