Page 2 For technical questions, please call 1-888-866-5797. 70262
Specifications
Maximum Load Capacity 450 lbs.
Maximum height 23-1/4″
Minimum height 7-1/4″
Saddle tilt 5°
Cradle size 13-1/16″ L x 6-5/8″ W
WARNING SYMBOLS AND DEFINITIONS
This is the safety alert symbol. It is used to alert you to potential personal injury hazards.
Obey all safety messages that follow this symbol to avoid possible injury or death.
Indicates a hazardous situation which, if not avoided,
will result in death or serious injury.
Indicates a hazardous situation which, if not avoided,
could result in death or serious injury.
Indicates a hazardous situation which, if not avoided,
could result in minor or moderate injury.
Addresses practices not related to personal injury.
IMPORTANT SAFETY INFORMATION
1. Study, understand, and follow all instructions
before operating this device.
2. Adequately support the vehicle
before starting repairs.
3. Do not exceed rated capacity.
4. Use only on hard, level surface
capable of supporting the load.
5. Before moving, lower the load to
the lowest possible height.
6. Failure to heed these markings may result in
personal injury and/or property damage.
7. Before moving the load, ensure that the load is
centered and secured with load-restraint device.
8. Only attachments and/or adapters supplied
by the manufacturer shall be used.
9. No alterations shall be made to this product.
10. Wear ANSI-approved safety goggles and
heavy-duty work gloves during use.
11. Keep clear of load while lifting and lowering.
12. Lower load slowly.
13. Do not use for aircraft purposes.
14. Inspect before every use; do not use
if parts are loose or damaged.
15. Use of this product is limited to the removal,
installation, and transportation in the lowered position,
of transmissions, transfer cases, and transaxles.
16. This tool requires a 1/2″ Drive Ratchet or
Breaker Bar to operate (neither one included).
Do not use an impact tool to operate jack.
17. The warnings, precautions, and instructions
discussed in this manual cannot cover all possible
conditions and situations that may occur. The
operator must understand that common sense and
caution are factors, which cannot be built into this
product, but must be supplied by the operator.
18. Store idle equipment. When not in use, tools must be
stored in a dry location to inhibit corrosion. Always
lock up tools and keep out of reach of children.
19. Do not roll the jack while loaded over rough
surfaces, such as concrete seams. Use on flat,
level, hard surface only. Wheels may scratch or dig
into less durable surfaces (such as linoleum or wood).
SAVE THESE INSTRUCTIONS.
To Next Page
Loading...
