Piusi Cube 56/33 User Manual (English)

Other manuals for Piusi Cube 56/33

Installation, Use And Maintenance Guide29 pages

Questions and Answers:

S
stephenmillerAug 3, 2025
What to do if the Piusi Dispenser motor is not turning?
- S
  Susan MartinezAug 3, 2025
  If the Piusi Dispenser motor isn't turning, here's what you can check: * Ensure the starting handle is in the ON position. * Reset the external residual current circuit-breaker. * Inspect the electrical connections. * Replace any burned-out fuses in the electric panel. * Change the faulty switch on the electric panel. Also, if the rotor is jammed, dismount it, check for damage or obstructions, and remount it. Finally, ensure the voltage is no more than 5% below the nominal voltage.
A
ashley53Aug 8, 2025
Why is my Piusi Dispenser meter accuracy not sufficient?
- O
  osmithAug 9, 2025
  If your Piusi Dispenser meter isn't accurate enough, it could be due to air in the suction line. Check the seals of the connections to resolve this. Another possible cause is a dirty measuring chamber. Try cleaning the meter measuring chamber.
R
Ruben WaltersAug 14, 2025
What to do if Piusi Cube 56/33 fluid is leaking?
- A
  adamweberAug 14, 2025
  If you notice fluid leaking from the Piusi Dispenser, check the seal of the connections and inspect the condition of the rubber tubes.
R
robin85Aug 21, 2025
What to do if the meter chamber is obstructed in Piusi Cube 56/33?
- S
  Samantha TylerAug 21, 2025
  If the meter chamber in your Piusi Dispenser is obstructed, clean the meter chamber.
A
Adriana WilliamsAug 27, 2025
What to do if the check valve is blocked in Piusi Cube 56/33 Dispenser?
- C
  Charles MartinAug 27, 2025
  If the check valve in your Piusi Dispenser is blocked, clean or replace it.