Piusi Cube 70/33 User Manual (English)

Other manuals for Piusi Cube 70/33

Questions and Answers:

J
Jasmine Harper MDAug 8, 2025
What to do if the Piusi Cube 70/33 Dispenser motor is not turning?
- E
  Elizabeth LunaAug 8, 2025
  If the Piusi Dispenser motor isn't turning, here's what you can check: * Ensure the starting handle is in the ON position. * Reset the external residual current circuit-breaker. * Inspect the electrical connections. * Replace any burned-out fuses in the electric panel. * Change the faulty switch on the electric panel. Also, if the rotor is jammed, dismount it, check for damage or obstructions, and remount it. Finally, ensure the voltage is no more than 5% below the nominal voltage.
S
Stacey GambleAug 15, 2025
Why is my Piusi Cube 70/33 meter accuracy not sufficient?
- P
  Paula DiazAug 15, 2025
  If your Piusi Dispenser meter isn't accurate enough, it could be due to air in the suction line. Check the seals of the connections to resolve this. Another possible cause is a dirty measuring chamber. Try cleaning the meter measuring chamber.
P
Penny FernandezAug 20, 2025
What to do if Piusi Cube 70/33 Dispenser fluid is leaking?
- K
  Kim RobertsonAug 20, 2025
  If you notice fluid leaking from the Piusi Dispenser, check the seal of the connections and inspect the condition of the rubber tubes.
R
Roger WilsonAug 27, 2025
What to do if the meter chamber is obstructed in Piusi Dispenser?
- R
  Ricky FrankAug 27, 2025
  If the meter chamber in your Piusi Dispenser is obstructed, clean the meter chamber.
T
Terry EvansSep 1, 2025
What to do if the check valve is blocked in Piusi Cube 70/33?
- S
  Sheri BennettSep 1, 2025
  If the check valve in your Piusi Dispenser is blocked, clean or replace it.

Piusi Cube 70/33 Specifications

General

Flow Rate	70 L/min
Fluid Compatibility	Diesel
Protection rating	IP55
Power Supply	230 V
Pump Type	Vane Pump
Nozzle	Automatic
Meter Type	Mechanical
Hose length	4 meters