. Technical specifications
CUBE / > /
V / Hz - ~ S (CONTINUO)
CUBE / > /
V / Hz - ~
S (CONTINUO)
CUBE / > /
V / Hz - ~
S (CONTINUO)
CUBE / > /
V / Hz - ~
S (CONTINUO)
CUBE /* > /
V / Hz - ~
S (CONTINUO)
CUBE /* > /
V / Hz - ~
S (” ON – ” OFF)
CUBE DC V
V DC
S (” ON – ” OFF)
CUBE DC V*
V DC
S (” ON – ” OFF)
CUBE dispenser
model
Supply
voltage
Flow rate
(l/m)
Duty
cicle
Operation in bypass mode is permied only for short periods (/ minutes max.).
The flow rate value is referred to the following operating conditions:
fluid: diesel fuel
temperature: °C
Suction conditions: the suction line and pump position with respect to the fluid level is such as to create a
. bar vacuum at nominal flow rate.
With different suction conditions higher vacuum values may be created thus reducing the flow rate
considering the same back-pressure values.
To obtain the highest performance it is essential to limit pressure drops on the suction line as far as
possible by observing the following recommendations:
¦ shorten the suction line as much as possible;
¦ avoid elbows and restrictions;
¦ keep the suction strainer clean;
¦ use hose of recommended diameter or larger (see installation).
The pump burst pressure is bar.
ATTENTION
Shown performances are relevant to the inlet pressure loss of bar.
To Next Page
Loading...
