Piusi E300 - Start-Up and Every Day Use; General Information; Every Day Use; No Power Supply

M0362 A ml
50 /56
Installation, use and maintenance
N START-UP AND EVERY DAY USE
N1 GENERAL INFORMATION
FOREWORD Make sure that the hoses and line accessories are in good condition. Oil
leaks can damage objects and injure persons.
Extreme operating conditions can raise the motor temperature and, consequently,
cause the thermal protection switch to stop it.
Switch off the unit and wait for it to cool down before using again. The thermal
protection automatically turns off when the motor is sufficiently cool.
ATTENTION Before starting up the system, make sure that the unit has been assem-
bled correctly, with all lids correctly closed.
N2 EVERY DAY USE
1
Supply voltage to the system by connecting the plug to the mains
2
If flexible pipes are used, aach the ends of the piping to the tanks. In
the absence of an appropriate slot, solidly grasp the end of delivery pipe
before beginning dispensing.
3
Before starting the pump make sure that the delivery valve is closed (dis-
pensing nozzle or line valve).
4
Turn the ON/OFF switch on.
5
Open the delivery valve, solidly grasping the end of the tubing.
6
Close the delivery valve to stop dispensing.
7
When dispensing is finished, turn off the pump.
ATTENTION
Operation with delivery closed is only allowed for short periods (2 to 3
minutes maximum). Aer use, make sure the pump is turned off.
N3 NO POWER SUPPLY
NOTE An electric power failure, with the consequent accidental stopping of the
unit, can be caused by:
- safety device tripping (if present at the system inlet)
- drop in line voltage
- fuse burnt out
O NOISE LEVEL
Under normal operating conditions noise emission for all models does not exceed the value of 70 dB
“A” at a distance of 1 Meter from the electric pump.