Piusi cube mc - User Manual

Questions and Answers

L
Linda ColemanJul 27, 2025
Why is the Piusi cube mc Water Pump flow rate low?
- M
  Michael EllisJul 27, 2025
  If the Piusi Water Pump exhibits a low or no flow rate, several factors could be responsible. Start by ensuring the suction pipe isn't resting on the tank bottom; raise it if it is. Check for blockages in the check valve, tank filter, and pump filter, cleaning or replacing them as needed. Inspect the connections for air leaks and the condition of rubber tubes for fluid leaks, addressing any issues found. Also, make sure that the meter chamber is not obstructed. If the suction pressure is too high, lower the CUBE MC relative to the tank or use wider tubing. For high head loss, opt for shorter or wider tubing. Ensure the suction tank has sufficient fluid. If the motor speed is low, check and adjust the voltage, potentially using larger cables.
A
Amanda StewartAug 2, 2025
How to fix a Piusi cube mc when the motor is not turning?
- C
  Christie RomanAug 3, 2025
  If the motor of your Piusi Water Pump isn't turning, begin by verifying that the operating lever is in the ON position. Check all electrical connections and reset the external residual current circuit-breaker. Replace any burned-out fuses on the switchboard. If the rotor seems jammed, carefully dismount it to inspect for damage or obstructions, then remount it. If problems persist, it may be necessary to contact the Service Department.
J
Justin JohnsonAug 8, 2025
What to do if my Piusi cube mc Water Pump meter is not accurate?
- S
  sarah85Aug 8, 2025
  If your Piusi Water Pump's meter isn't accurate enough, start by checking the connection seals for air in the suction line. If air is present, tighten the connections. Also, calibrate the meter.
J
Janet JacksonAug 13, 2025
Why won't my Piusi cube mc Water Pump start with the nozzle closed?
- C
  croyAug 13, 2025
  If the motor of your Piusi Water Pump won't start when the nozzle is closed, it might be due to electric voltage being too low. Check that the voltage is not more than 5% below the nominal voltage.
E
Evelyn BrewerAug 20, 2025
Why does the Piusi cube mc nozzle trip too often?
- K
  Karen BarkerAug 20, 2025
  If the nozzle of your Piusi Water Pump trips too often, it might be due to a blockage in the automatic stop probe hole. Clear any dirt or obstructions from this hole.